Rear arch glue pull (bodyline dent) Ford Fiesta ST

Brand new Ford Fiesta with a sharp dent running through the rear arch swege/bodyline of the panel. Access to the rear of the panel was restricted in order to perform a tradition PDR repair of massaging out. Because of this a glue pulling dent repair was required.

Using hot glue and specialist nylon pads i carefully drew the dent out from the front of the panel using a number of different extraction techniques along with some careful hammer blending. As one of the photographs shows, the dent only moves a small amount following the first set of pulls.

With this being quite a sharp dent penetrating the bodyline, when we begin to pull the dent, the side walls lift as well as the centre of the dent. What’s required here is some careful hammer blending in order to reduce the high dent sides thus reducing the stress placed on the whole dent. ¬†Over time with this process repeated up to 30 times, we see the centre of the dent lift whilst being able to contain the dent to its original shape and size.

This is a very advanced PDR repair that takes great skill and understanding of what is actually happening within the damaged area. There are all kinds of stresses going on within the metal on a dent such as this and its important that this process is carried out with the utmost care and attention as to not damage the paintwork or worsen the dented area further.

Repair time = 1 hour 10 mins